July 2020
SMTWTFS
1234
567891011
12131415161718
19202122232425
262728293031

Login Form

FaceBookTwitterGoogle+

PRIME FASTCRETE 360

FAST SETTING CONCRETE SOLUTIONS

Rapid flexural gains. Natural Cement based colors, High flexural strength, abrasion, and weather resistance, Economical. Self-compacting. Contains no chloride admixtures.


PRIME FASTCRETE 360

  • Rapid flexural gains – will accept vehicular traffic in 6 hours
  • Natural Cement based colors
  • High flexural strength, abrasion, and weather resistance
  • Economical – can be ‘bulked-out’ with graded aggregate in some locations
  • Self-compacting – eliminates honey combing and voids
  • Contains no chloride admixtures

 

Rapid-setting patch repair concrete for roads and freeways/tolls

Uses

For the emergency reinstatement of damaged or deteriorated concrete. The material is particularly suitable for repairs to roads, freeways, airport runways, aprons and areas where wheeled traffic requires fast return to service. It may use internally and externally.

 

Description

Prime Fastcrete is supplied as a ready to use blend of dry powders and graded aggregates which requires only the site addition of clean water to produce a highly consistent, high flexural strength, free-flowing repair concrete which self-compacts. Prime Fastcrete exhibits excellent thermal compatibility with concrete and good water repellent properties.

 

Technical Support

PSI offers a comprehensive range of high performance, high quality concrete repair, and construction products. In addition, PSI offers a technical support service to specifiers, end-users, and contractors, as well as on-site technical assistance in locations all over the world.

 

Design Criteria

Prime Fastcrete is designed for horizontal use but can also be used vertically the aid of formwork. It is suitable for use at nominal thickness of 100mm. Thicker sections up to 250mm may be applied by the addition of graded silt-free aggregate.

The material should not be applied at less than 20mm thickness. Aggregate should not be added at applied thickness between 20mm and 100mm without specific advice from PSI. Horizontal surfaces areas should be restricted to bay sizes not exceeding 4m2 and 12m2 where filled with aggregate. Consult the local PSI office for further information.